Recently installed the EAF drive, couplings, bracket and installed the software driver. The focuser performed well and above expectations on the laptop while using sharpcap for camera control and driving the focuser.
However, I changed the telescope for visual observations, removed the camera and used an eye piece. The manual hand controller would not move or activate the focuser. It appeared to be dead.
Any suggestions as to what is occurring?
that last 1mm on the cable connector did the trick. I wasn't confident in pushing the cable completely in, by force. Once fully connected all good.
This form, with your information, solved my problem! The hand control was not working. Once I pushed the connectors in farther, it works.