When I try to use the camera with that pc, my pc doesn't recognize the camera as USB3 device but USB2.
I can check the data transfer speed with "lsusb -t" and I know if the connection is USB3 or USB2.
Then, once I unplug the cable and plug it to the PC again, the camera is recognized as USB3 and the data transfer speed becomes much higher(USB3.0).
I need to get USB3's fast data transfer as soon as the board gets booted, without unplugging cables since now it's not that easy to access to the board and cable.
I tried usb reset command like
echo -n "1-2.1" > /sys/bus/usb/drivers/usb/unbind
but this doesn't change anything
I suppose somehow I can get USB3 connection at booting.
Hope anyone knows about this issue