ZWO EAF recalibration possible ?

Focusers, Filters, Barlows etc..

Moderators: Sam, Sean.Wang

Post Reply
jbarabas
Posts: 13
Joined: Sat Feb 18, 2017 11:57 am

ZWO EAF recalibration possible ?

Post by jbarabas » Sat Sep 07, 2019 12:41 pm

Hi,

Is there a way to recalibrate the end points of the focuser, because I could only do it once in the Ascom driver. I have asked this question previously but there was no reaction,

Clear skies,
Janos

Katherine.Tsai
Posts: 194
Joined: Fri Dec 07, 2018 10:24 am

Re: ZWO EAF recalibration possible ?

Post by Katherine.Tsai » Tue Sep 10, 2019 9:10 am

Yes you can reset the maximum steps.(end points)

jbarabas
Posts: 13
Joined: Sat Feb 18, 2017 11:57 am

Re: ZWO EAF recalibration possible ?

Post by jbarabas » Wed Sep 18, 2019 5:21 pm

Thanks for your reply ! Please explain where is that option, I don't see any option to reset the endpoints in the ASCOM driver.

Katherine.Tsai
Posts: 194
Joined: Fri Dec 07, 2018 10:24 am

Re: ZWO EAF recalibration possible ?

Post by Katherine.Tsai » Thu Sep 19, 2019 7:50 am

Please see the attached photo.
Attachments
settings (2).png

jbarabas
Posts: 13
Joined: Sat Feb 18, 2017 11:57 am

Re: ZWO EAF recalibration possible ?

Post by jbarabas » Thu Sep 19, 2019 3:41 pm

Thank You,

I know that screen. The point is that I would like to adjust the zero position of the focuser, not the maximum range. I don't see an option how to do that.

Katherine.Tsai
Posts: 194
Joined: Fri Dec 07, 2018 10:24 am

Re: ZWO EAF recalibration possible ?

Post by Katherine.Tsai » Fri Sep 20, 2019 5:59 am

Hi Sir/Madam,
OK, do not worry, that would be easy.
You can move the EAF to the position where you want to set as the zero position, and then click set as zero position, then done.:)

jbarabas
Posts: 13
Joined: Sat Feb 18, 2017 11:57 am

Re: ZWO EAF recalibration possible ?

Post by jbarabas » Fri Sep 20, 2019 6:13 am

Thank you !

Katherine.Tsai
Posts: 194
Joined: Fri Dec 07, 2018 10:24 am

Re: ZWO EAF recalibration possible ?

Post by Katherine.Tsai » Fri Sep 20, 2019 7:54 am

My pleasure.:)

Post Reply