Have just bought ASIAIR
And have it connected to a Skywatcher NEQ6 via the SynScan hand controller .
Once the mount is polar aligned and I have done a three star alignment what do I have to do next to use ASIAIR ?
Thanks for any advice
thanks for the reply
I have connected to SynScan and tablet as per your reply photo.
Also have control over the mount
But I do not know what to do after the three star alignment .
Should I try to sync after alignment ?.
At the moment my main imaging camera is not compatible with ASIAIR, I am looking forward to getting ASI294MC pro soon ,so will not be able to plate solve at the moment.
Once again many thanks
Yes， plate solve is needed.
here is my steps below for your reference :
step 1 :focus(main camera and guide camera)
step 2: PA(polar alignment）
step 3::preview(plate solve succeed and sync to mount)
step 4: select your object and goto
step 5:guiding (calibration and guiding, enable dither or not )
step 6：auto run（set your auto run schedule and run it）
step 7:you can set "mount go to zero position or turn off asiair when you start an auto run in step 6)
Thanks for your help
I could not figure out the correct procedure for this looks as if i will be getting ASI294MC PRO sooner that way I can use ASIAIR to its full potential.
Once again many thanks for your help and advice