Page 1 of 1

ZWO EAF recalibration possible ?

Posted: Sat Sep 07, 2019 12:41 pm
by jbarabas
Hi,

Is there a way to recalibrate the end points of the focuser, because I could only do it once in the Ascom driver. I have asked this question previously but there was no reaction,

Clear skies,
Janos

Re: ZWO EAF recalibration possible ?

Posted: Tue Sep 10, 2019 9:10 am
by Katherine.Tsai
Yes you can reset the maximum steps.(end points)

Re: ZWO EAF recalibration possible ?

Posted: Wed Sep 18, 2019 5:21 pm
by jbarabas
Thanks for your reply ! Please explain where is that option, I don't see any option to reset the endpoints in the ASCOM driver.

Re: ZWO EAF recalibration possible ?

Posted: Thu Sep 19, 2019 7:50 am
by Katherine.Tsai
Please see the attached photo.

Re: ZWO EAF recalibration possible ?

Posted: Thu Sep 19, 2019 3:41 pm
by jbarabas
Thank You,

I know that screen. The point is that I would like to adjust the zero position of the focuser, not the maximum range. I don't see an option how to do that.

Re: ZWO EAF recalibration possible ?

Posted: Fri Sep 20, 2019 5:59 am
by Katherine.Tsai
Hi Sir/Madam´╝î
OK, do not worry, that would be easy.
You can move the EAF to the position where you want to set as the zero position, and then click set as zero position, then done.:)

Re: ZWO EAF recalibration possible ?

Posted: Fri Sep 20, 2019 6:13 am
by jbarabas
Thank you !

Re: ZWO EAF recalibration possible ?

Posted: Fri Sep 20, 2019 7:54 am
by Katherine.Tsai
My pleasure.:)