Page 1 of 2

red light

Posted: Mon Jan 07, 2019 1:32 pm
by trampe
I try to download my pictures to my computer but how do you open fit file? Then when I put the card back in it just stays red and i cant hook up.

Re: red light

Posted: Mon Jan 07, 2019 8:05 pm
by DaveFrance
You can open a fits file with Fits Liberator or Fitswork4 both free downloads. I would suggest you turn off Asiair and remove power before taking out the card. It will then reboot the firmware when you re-insert and plug power in again.

Re: red light

Posted: Mon Jan 07, 2019 9:21 pm
by trampe
I try that it did not work

Re: red light

Posted: Tue Jan 08, 2019 1:39 am
by Sam
trampe wrote:
Mon Jan 07, 2019 9:21 pm
I try that it did not work
Maybe your system files on SD card has been damaged. Which OS (Mac or Windows or Linux) do you use? We will give you the right solution about restoring and get images(fits).

Re: red light

Posted: Tue Jan 08, 2019 1:42 am
by trampe
windows

Re: red light

Posted: Wed Jan 09, 2019 1:20 am
by Sam

Re: red light

Posted: Sun Jan 13, 2019 12:18 am
by trampe
I tried it did not work don't what to do?

Re: red light

Posted: Tue Jan 15, 2019 8:36 pm
by billybooby
Also have same problem 5g network not finding asiair even tried new memory card frustrating please reply with solution thanks

Re: red light

Posted: Wed Jan 16, 2019 8:41 pm
by HDastro
Hi all, I believe there are 2 questions being asked by Trampe. 1: How to open FIT files, and 2: When putting back the SD card, the light stays red and cannot connect.

Seems to be 2 issues here, so, as DaveFrance responded "You can open a fits file with Fits Liberator or Fitswork4 both free downloads."

Now, to the other issue from Trampe, the light remains red and cannot connect. ZWO replied that the SD could be corrupt and provided a solution to backing up the image file to another SD card, and that did not fix the issue as per Trampe.

If Trampe did not backup his original image, and if it is corrupt, any backing up now will not fix his problem. (Garbage in, Garbage out) as we say in the IT world.

My question to Trampe is, and I am assuming that the ASIair was working prior, usually a RED light, as I had made this mistake was, using a power supply of 12 volts, but not enough AMPS (2.5 Amps is needed). Is this your case Trampe? AGAIN, I am assuming this ASIair was working perfectly before, but I am just curious.

If so, I can only see a corrupt card and why DaveFrance mentioned it is always better to shutdown the ASIair or any Raspberry Pi unit before removing the SD card. A new image file might be needed to correct the issue and that Trampe try's the solution provided by DaveFrance for opening FIT files once he has ironed out the poissible card issue and gets back his connectivity.

A bit more information of steps taken in a bit more detail would be good to have here from Trampe

Just my opinion.

Hope some of this helps.

Re: red light

Posted: Thu Jan 17, 2019 1:42 pm
by billybooby
Hi I tried to put file on to new card all was going well green light flashed then red but asiair does not give a signal to connect how do I get new image file and steps to put on card thanks