Page 1 of 1

Default values ASI Air

Posted: Mon Feb 10, 2020 2:32 pm
by gundamrx91
Could you tell me the default values of any section in order to have a reference?
Thanks

Giuseppe

Re: Default values ASI Air

Posted: Wed Feb 19, 2020 6:01 am
by Sam
there is no default value, you can read the meaning from our manual

Re: Default values ASI Air

Posted: Wed Feb 19, 2020 7:14 am
by gundamrx91
I'm sorry but i remember at the first execution of the program the guide settings were different from the last firmware update, so every time I have to check every single parameter because I don't know if it's right.

Giuseppe

Re: Default values ASI Air

Posted: Thu Feb 20, 2020 10:45 am
by ASIAIR@ZWO
gundamrx91 wrote:
Wed Feb 19, 2020 7:14 am
I'm sorry but i remember at the first execution of the program the guide settings were different from the last firmware update, so every time I have to check every single parameter because I don't know if it's right.

Giuseppe
Hey Giuseppe, the values will be saved on your ASIAIR device after you used. BUT there is no default values for the first time using. As you said, after firmware updated, may some values were changed cause the new features.

Re: Default values ASI Air

Posted: Thu Feb 20, 2020 2:09 pm
by gundamrx91
Ji.zwo wrote:
Thu Feb 20, 2020 10:45 am
gundamrx91 wrote:
Wed Feb 19, 2020 7:14 am
I'm sorry but i remember at the first execution of the program the guide settings were different from the last firmware update, so every time I have to check every single parameter because I don't know if it's right.

Giuseppe
Hey Giuseppe, the values will be saved on your ASIAIR device after you used. BUT there is no default values for the first time using. As you said, after firmware updated, may some values were changed cause the new features.
Ok, thanks for the information ;)
Giuseppe

Re: Default values ASI Air

Posted: Fri Feb 21, 2020 3:33 pm
by ASIAIR@ZWO
gundamrx91 wrote:
Thu Feb 20, 2020 2:09 pm
Ji.zwo wrote:
Thu Feb 20, 2020 10:45 am
gundamrx91 wrote:
Wed Feb 19, 2020 7:14 am
I'm sorry but i remember at the first execution of the program the guide settings were different from the last firmware update, so every time I have to check every single parameter because I don't know if it's right.

Giuseppe
Hey Giuseppe, the values will be saved on your ASIAIR device after you used. BUT there is no default values for the first time using. As you said, after firmware updated, may some values were changed cause the new features.
Ok, thanks for the information ;)
Giuseppe
Anytime.