Sharpcap image control

any question related to our SDK and driver

Moderators: yang, Support@ZWO

Post Reply
Coastliner
Posts: 2
Joined: Tue Jul 12, 2016 10:42 am

Sharpcap image control

Post by Coastliner » Mon Oct 17, 2016 12:44 pm

Hi All,

I have a ZWOASI178mm camera, on the Sharpcap control panel there are two options for image control, one for the displayed image as presented on screen and another that modifies the captured image. I would prefer not to have control over the captured image other than selecting an exposure time, because if you are taking long exposures you can waste time choosing the best image. I would prefer to capture an unmodified image and alter it in post-processing. Is there any way to switch the captured image modifiers off, or are there values that can be set that will just capture a "flat" image? I hope this makes sense!

Cheers,

Neil.

Post Reply