Ascom timing problem

any question related to our SDK and driver

Moderators: yang, Support@ZWO

Post Reply
brew
Posts: 1
Joined: Fri May 29, 2020 10:28 pm

Ascom timing problem

Post by brew » Fri Jun 12, 2020 5:04 pm

I am using an asi120 mini as a guide camera under Maxim. The Ascom driver has a timing problem.

Normally, when calibrating the guider, Maxim does the following steps:
1) expose an image, 3 seconds for example.
2) Find the star position.
3) Move the scope for perhaps 10 seconds.
4) After the move completes, take another image. Calculate the number of pixels moved.
5) repeat 1-4 for each direction.

With the ASI driver step 4 fails - the system does not wait for the move to complete, but starts exposing right away. This gives a star streak as the mount is still moving.

This also fails the same way when using the Move dialog from the Guider tab. For example, specify to move in the Y direction some amount then expose a new image. The new exposure starts right away rather than waiting for the move to complete.

Using Maxim 6.20, current downloaded ASI driver, Ascom 6.3, Windows 10.

Tech@ZWO
Posts: 132
Joined: Mon Nov 26, 2018 9:59 am

Re: Ascom timing problem

Post by Tech@ZWO » Tue Jul 07, 2020 3:25 am

Hi
It's In the rainy season here,we will test it outside when we get the clear skies

If you got the AISAIR,you may have a try for the guiding

Post Reply