Maxim error with ZWO ASI174mm-cool "Your exposure time is not between 0 and 0"

ASI's Range of Specialised CMOS camera's

Moderator: Sam

Post Reply
User avatar
mathieuclerte
Posts: 6
Joined: Sat Apr 27, 2019 1:48 pm

Maxim error with ZWO ASI174mm-cool "Your exposure time is not between 0 and 0"

Post by mathieuclerte » Tue Apr 30, 2019 1:21 am

Hi,

With a ZWO ASI174mm-cool used as guide camera, we were doing either focus or calibration (can't remember) and MaximDL came up with the following error message, which prevented us to take an exposure :

"Your exposure time is not between 0 and 0"

We disconnected from the camera, and could not reconnect.

The only solution was to reboot the PC, as restarting MaximDL was not enought even to reconnect to the camera (it did not want to connect).

I have addressed this issue with DiffractionLimited and they confirmed it is a driver issue. As MaximDL uses the ZWO ASCOM Driver, is there something we can do to identify where the problem comes from ?

Thanks in advance for your help,

Regards
Mathieu

User avatar
Support@ZWO
Posts: 795
Joined: Mon Apr 24, 2017 10:08 am

Re: Maxim error with ZWO ASI174mm-cool "Your exposure time is not between 0 and 0"

Post by Support@ZWO » Tue May 07, 2019 3:08 am

Hi
Do you try to use other softwares? such as ASICAP. to judge if the camera is working or not.
Location:lon=120.6 lat=31.3
Suzhou China

Post Reply