Hello! Dear developers, i have met with one problem with my Newton and Asi. I can’t set polar alignment, because something strange occur. When everything has been settled and I proceed to the stage of alignment with the help of the screws of my mount, then when I turn these screws the indicator in the program shifts in the wrong directions. I tried to align the polar one in this way, but I ran into a problem further, when I tried to automatically adjust to an object, I was told that “Auto center field, distance ro far”. Also, by clicking on Plate solve, everything is considered, but when trying to tune to the object, it gives “sync out of range.You can’t sync the mount in the 5 degrees range around the NNC”. My other telescope (Refractor) did not have such problems. Please tell me, what could be the problem?